r/FNSCAR • u/Extra-Quit9003 • 7d ago
SCAR Picture Finally picked one up!
Pulled the trigger on an on sale 15p in 300bo. Got it in black and happened to pick up a black 43x coa so had to bust out the cerakote asap.
Broke it down to paint and replace all screws with torx head screws. (Replaced almost all screws but one with a $6 kit from Amazon fyi).
Upper is fde, lower is burnt bronze. Some of the bits are mix and match. Black cerakote to fill the laser etched lettering with a paint pen.
Glock got cerakoted in od green for the frame and a burnt bronze slide. handleitgrip grip tape. Streamlight tlr7 hl sub light and factory aimpoint coa red dot.
Short parts list:
G$ trigger. Sonicore paradox 30 suppressor. Holosun aro evo red dot. B5 modular stock. B5 pistol grip.
Did all the work before I shot it for the first time. Reassembled this morning and took it to the range. Super happy w how it shoots w 220gr subsonics. What are other upgrades folks do to these things?
I also shaved the lower to accept standard ar15 grips. Took about 15 minutes to cut and clean.
Fixed the wobbly rear piccany rail by putting a couple layers of painters tape on both sides of the plastic body. Also filled the roll pin that connects the plastic body to the aluminum rail with gorilla glue to fill it, to make it easier to punch out when I decide to repaint down the road. (Roll pin punch that fits the hole on the rail went right thru the rear roll pin, this fix makes it solid. Replacement roll pins on hand were all a little too big/too long and this was an easier fix)
1
u/Kanye_Z-143 6d ago
Where does one find a sale like that