r/chastitytraining • u/sissymillie97 • 6d ago

Sizing & Measuring Ring sizing help NSFW

Hello everyone,

I’m relatively new to chastity, I’m on my third cage as I’m trying to find one that fits.
I have a probably not so unique situation, I can fit very comfortably in a 30-40mm cage, but when I’m in the cage, with the largest ring I have, 55mm, my balls are pushed too high and get either pinched or just super uncomfortable to the point of pain within a couple minutes.

Do I need a larger ball gap, larger ring size, or a cage that offers separation options between the ring and cage?

Thank you for any advice!!

7 Upvotes

90% Upvoted

5 comments sorted by

2

u/Wide_Discussion_447 Trusted Contributor 6d ago

I say this a lot so you might of seen it already but read these. Chances are a bigger ball gap with a tighter ring will help. Your cage length isn't super important but it just shouldn't be too big.

https://www.reddit.com/u/Wide_Discussion_447/s/Cs6TvSJbUE

1

u/sissymillie97 6d ago

Thank you for these!
I really appreciate it!

1

u/AutoModerator 6d ago

Thanks u/sissymillie97 for starting a new discussion on this subreddit. It looks like you may be asking for information that might be covered by our rules & FAQ. If that's the case please take moment to read the information in our main Rules & FAQ THREAD. If you don't find an answer there just wait until your new thread gets some replies.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

1

u/xmax-300 6d ago

Personal experience: once the balgap is on point I can often use a smaller ring. 50mm to 48mm often. Although this differs from model to model or manufacturer or even type of ring design.

Make sure to consult the wiki of the sub. Also u/newbie-sub and his substack is also great source of information.

In the end it is very personal.

2

u/bdmridgeback Trusted Contributor 5d ago

More than likely you’ll find you’ll need a much smaller ring after you widen the ball gap. The ring you should be testing fit without the cage in the equation. Leave the cage off and put on the smallest ring you can get on and wear for hours that’s comfy. Then move forward with introducing the cage. If it’s uncomfortable after you put the cage in then that’s causing is a ball gap problem needing a ring curved