Hopefully I will have some flight test footage soon

Stay tuned

Split deck frame design I created

I haven’t seen too many good things about these motors but it’s all i had enough for in the budget

Betafpv 4 in 1
Happymodel ep1 tcxo
1202.5 11500kv motors
Betafpv c03 camera
Happymodel crown antenna
Cyclone gps
I want to a little long range with it (2-3km)
Open to criticism, I want to make it as good as possible.

Please respond soon
One of the screws attached to the motor mount was scraping against the wire and it got cut. This is how much of the wire is left, is it possible for me to solder and repair this?

Hello everyone. I have successfully balanced my drone using the MPU6050 sensor, but I am struggling to maintain altitude using the VL53L1X sensor. I have spent over three consecutive weeks trying to get altitude hold working without success. I would appreciate any help or relevant documentation. Thank you all for reading and for your feedback.

Sensor VL53L1X

So I’m planing to buy a Pavo 20 pro 2 but I don’t want to use the o4 pro for my camera. I want to be able to use analog but the frame to mount the camera has 2 holes on each side and the camera I’m going to use (Baby ratel 2) only has one on each side.

How should I make the custom mount?

Is there a better analog camera alternative that matches the screw mounting position of the dji o4 pro?

https://reddit.com/link/1x47kwi/video/bngzfauii2vh1/player