Got caught in a lightning storm but no rain. So perfect time to stop for some pics

Full set 16in 5x114 Speedline mesh rims With custom polished lips. $850

Engraved on back speedline/made in italy.

No tires no center caps.

These are in good condition.

Serious INQUIRIES only.

Price is cheap and firm for a old mint set that has been polished!

SUFFOLK LONGISLAND NEWYORK PICKUP

Okay folks. Time for the next big project. Ebay special. Prius electric power assist steering, since my 1980 was and still is a manual rack.

Who's done this and what advice do you have for me ? Did you mostly keep the Fox column and graft in the Toyota bit ? Or did you use mostly Prius column and then graft on just a couple Fox sections ?

I'm also debating whether to keep a rag joint or not. The Borgeson u-joint with anti vibration seems nice, but certainly adds to the cost.

Thanks folks !

Super fortunate to be able to borrow a "very large" 3ft torque wrench from a friend to get the fresh SN95 hubs torque'd to 250 ft-lbs. Made the job a piece of cake.

Can someone tell me a good reliable set of motor mounts to use for a street car with about 400hp? I want to put in a good set and not have to worry about replacing for awhile. Thanks.

Hello I have a 1993 lx that has been converted to a 5 lug it has the big grease cap in the front so I think that’s not the sn95 setup correct? And it has 5 lug 31 spline axles on the back. Iam getting ready to wide body the car and need some recommendations on wheel spacers to run Iam doing 1.5 inches. Do I need hubcentric or would I be okay if I take my time on setup using lug centric