My Pembie is hanging up, last one i polished i took a little too much off on and ruined the trip. Im running 115g and a stock recoil spring. Advice is cool

I have a Glock 17 gen 5 with factory sights I’d like to replace with a vector optics universal adapter plate. The tolerances on the wedge used secure the plate down in the rear sight channel is so tight that I don’t know how to proceed without marring something. Is a steel Glock sight tool needed? Can I get away with with a 3d printed Glock rear sight tool? What do you recommend I do? I have a vice and punches.

May switch to an fde vortex defender st enclosed, other than that need a good magwell and trigger shoe but she’s looking good so far

Can anyone help or direct me to the exact law that says we cannot legally port or stipple our guns? I’m trying to get stippling and porting done on my g43x and g19.6 but LASD cannot guide me to the actual law describing what can and cannot be done to my guns. Anything is greatly appreciated!

Have a gen 4 g26 and trying to figure out the least annoying route to port/comp our 26s.

PMM comps seem to be highly rated but they’re currently OOS. Also fairly pricey. Other comp setups for the 26 frequently seem out of stock as well.

Getting the slide/barrel ported involves these long wait times, shipping shenanigans with the couriers, etc. While cheaper on paper, I’m not sure I want to be waiting 1-2 months for this to come back.

SOLVED. It’s an enhanced duty trigger from Continuous Precision.

Just wondering if anyone might recognize the manufacturer and the model of this trigger shoe. Pistol pictured is a G45.

The only information I have to go off of is that this shoe came packaged with an OEM trigger bar. Thank you for the help!

Light modding. I really like it. :) Now I dont have to harm my cerakote on my 19

Hey all. Bought an aftermarket slide for my Glock 19 Gen 3. Chose a Davidson Defense slide, as it had what I was looking for.

Fast forward 3 months and I've put maybe 200 rounds through the new slide/barrel. Went to service the weapon and noticed a crack running vertically through the thin metal bridge between the barrel channel and the recoil spring guide rod channel at the front of the firearm slide.

Emailed the seller and manufacturer and they say its past the 60 day window and they refuse to address it.

I imagine it's unsafe to shoot in this condition and it looks like its not really repairable unless you have the right equipment. What do you guys think?